We often get confused about using these terms – Development Length, Anchorage Length, and Lap Length.
The steel reinforcement that is prolonged into concrete to avoid steel slippage and to transfer the load to the concrete bond smoothly is known as Development length or Anchorage Length.
The steel reinforcement provided which does not require to carry any tension stress but need to restrain is known as development length (Ld).
Development length differs according to the grade of concrete, steel reinforcement, and design load.
As per IS Code 456:2000, (Clause 26.2.1) Development length can be calculated using the below formula
Ld = Фσs/4τbd
Where,
Ф = diameter of the reinforcement bar
σs = Stress developed in a bar at section considered at load design
τbd = Design bond stress
Note- The formula can be used for both the Limit state and the Working stress method. It only differs in design bond stress value.
Assume – Finding development length in Limit state method, For M30 grade of concrete & Fe500 steel grade
Diameter of bar = 12 mm
Stress in bars = 415 N/mm2 (For Fe415 Bars)
Design Bond Stress, τbd = 2.4 N/mm2
Ld = Фσs/4τbd
Ld = Ф*415/4*2.4 = 43Ф
Ld = 43Ф
According to IS 456:2000, the minimum development length should be 41Ф.
The steel prolonged to overlap on another steel reinforcement for steel continuity and to transfer the load to another steel reinforcement is known as Lap Length.
The manufactured steel is mostly 12m in length. To prolong the steel reinforcement for the required length (more than 12m) and safely transfer the loads from one rod to another, lap length is provided.
According to IS 456:2000, the minimum length should be 24-55d, where d is the bar’s diameter. The lap length should not be less than 75mm.
Development Length | Lap Length |
Steel to Concrete – Reinforcement provided to prolong the connection of steel to concrete | Steel to Steel – Reinforcement provided for steel continuity and to transfer loads to another reinforcement. |
Development length does not carry any tension force. | Lap length carries tension force to another reinforcement |
Minimum development length should be 41Ф | Minimum lap length should be 24-55Ф |
Happy Learning 🙂
Before starting any civil engineering work, regardless of branches, horizontal, vertical, and angular measurements of…
The data measurements gathered from surveying helps establish the plan and design of all civil…
Surveying is the art and science of civil engineering that determines the relative (comparable) position…
The formation of cracks on the concrete surface may lead to reduce the durability of…
Understanding the different levels of structure seems a bit of a daunting task. Don’t worry…
We knew that pipes are used to transport gas or liquid substance from one place…