The strength and durability of concrete depend on many factors, as listed below.
Compaction of concrete is the process of consolidating fresh concrete after pouring it over the shuttering area, covering the reinforcement & making it an impermeable element. It is one of the essential properties of concrete.
The concrete’s strength reduces up to 30% when 5% of air voids are present in concrete.
The primary purpose of the compaction is to remove the air voids which occur in the freshly mixed concrete. The voids are very harmful to the concrete element, and it impacts the concrete durability.
The compaction enhances the concrete bonding between the reinforcement & makes the concrete a substantial impermeable element.
The concrete compaction should be done as per IS code 456. The method of compaction & types of compactors has been explained below.
The compaction is to be done by both manual and mechanical methods.
The manual compaction method is applicable where the concrete poured location is not much more critical. The manual compaction is done by some construction tools such as
A wooden tamping plate with a size at the bottom of 10 sq cm and 2m in length will be used. The freshly poured concrete surface tamped by the wooden plate for compacting the concrete. It is mostly used to compact the PCC.
The heavy flat bottom plate rammer shall compact the foundation concrete. It is suitable mass foundation concrete and not used for roof slab, and other RCC works. You may see this method on basement filling to remove the undulations on the floor.
The tamping rod is used to consolidate the concrete where the concrete thickness is between 150mm and 200mm. The length of the rod will be a 2m long & sharp edge at the bottom.
The compaction has been done by poking of the concrete surface at random points by the rod.
Different types of mechanical vibration are mentioned below.
Generally, the fresh concrete is compacted by the internal vibrator in the slab, column & beam. The length of the needle shaft is 600mm to 2m, and the diameter of the vibration needle is 20mm to 100mm.
The needle immersed in the concrete and vibrated by the electrical charge, the concrete settled and surrounded near the reinforcement.
The external vibrator is used where the concrete thickness is very thin and the concrete congested by the reinforcement.
The external vibrators are fixed on the outer surface of the formwork. The form of work needs to be more firm to support this.
The surface vibrator is mostly used in concrete roads and large scale roof slabs or concrete floors. The vibration is given through the footplate by the electric charge to the concrete surface. The concrete depth should not exceed 250mm when using surface vibrators.
Table vibrators are used in laboratories to find the consistency of the concrete.
Plate vibrators are used mainly in road work to compact the concrete. The function of plate vibrators is similar to the earth rammer. The vibration plate beat the concrete surface to compact itself.
Happy Learning 🙂
Before starting any civil engineering work, regardless of branches, horizontal, vertical, and angular measurements of…
The data measurements gathered from surveying helps establish the plan and design of all civil…
Surveying is the art and science of civil engineering that determines the relative (comparable) position…
The formation of cracks on the concrete surface may lead to reduce the durability of…
Understanding the different levels of structure seems a bit of a daunting task. Don’t worry…
We knew that pipes are used to transport gas or liquid substance from one place…